“Making of a layered Resin Box”

In order to make a resin box, I’d pour a layer of resin within a duct tape sealed wood frame, let it cure, paint the surface, then pour another layer of resin. I’d repeat this dozens of times until a solid block emerged. Because each curing required 24-48 hours, it required a daily commitment to see the process through to the end. After pouring the resin, I’d use a heat gun to make the resin less viscous, and more prone to releasing air bubbles whipped up when the two parts of the resin were mixed. The curing occured within a rubber sealed vacuum chamber I invented. As air was sucked out from one valve, any air bubbles whipped into the mixture of resin came to the surface. Then, I’d open another valve which introduced an environment of pure carbon dioxide. This atmosphere mixture burst any air bubbles appearing on the surface of the resin. Because uncured resin is highly toxic to be breathed in or touch living cells, all of this had to happen while wearing a respirator and full chemical suit.